59667942601 Kenmore Refrigerator Parts List

Toe grille clip (clip, toe grille)

Sold individually.

Defrost thermostat (thermostat)

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Screw

This screw is sold individually.

Screw

Sold individually.

Defrost timer - 120v 60hz (defrost timer)

If there is ice build-up in the freezer you may need to replace the defrost timer.

Glass shelf (glass crisper)

Shelf only. Frame not including.

Door gasket (gasket panel)

This door gasket is for refrigerators. The door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the refrigerator. Safely store any food that could deteriorate while the door is open for this repair.

Screw

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw

This screw is sold individually

Plastic tubing (tubing)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Grille, shroud (grille)

Ice maker wire harness (wire harness)

This part connects to the electrical and allows power to flow through your appliance.

Single wheel assembly (cabinet roller)

This wheel is sold individually - purchase quantity needed.

Ice maker front cover (cover)

Bottom hinge pin (pin)

Sold individually.