59669899001 Kenmore Refrigerator Parts List

Compression nut (nut-sleeve)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Tray (tray-ice cube)

This fourteen cube ice cube tray is eleven inches long. It is all white in color and is made entirely of plastic.

Kick plate retaining clip (clip-toe grille)

This kick plate retaining clip is sold individually and is made entirely of metal. If you are needing the kick plate as well, remember to check with your model number as these clips may already be included.

Screw (screw-tf)

This screw is sold individually.

Ice stripper (stripper-ice)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw-sm)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw (screw-sm)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit (screw-tf)

Includes 2 screws.

Screw (screw-sm)

This screw is sold individually

Freezer door gasket (gasket-w fz dr (p69892000w0, p69894000c0))

This white door gasket is used to seal the freezer door when closed.

Plastic tubing (tube-plastic)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Ice maker wire harness (harness-ice maker)

This part connects to the electrical and allows power to flow through your appliance.

Ice maker front cover (cover-ice maker)

Bottom hinge pin (pin-bottom hinge)

Sold individually.

Refrigerator compressor start relay (relay-ptc)

The compressor start relay attaches to the compressor and helps start the compressor motor. Also knows as a start device combination relay.