Parts for Kenmore Models 59676252701

Door gasket - white (gasket panel)

This white door gasket is used to seal the freezer door when closed to keep the cool air inside and the room air out.

Easy Part #:: EAP3651282

Availability:: In Stock

Price:: $109.13

Icemaker motor kit (motor mold)

This kit includes the module motor, ejector arm, and ice stripper arm. The complete icemaker is sold separately.

Easy Part #:: EAP733947

Availability:: In Stock

Price:: $91.53

Water inlet valve - 120v 60hz (water valve)

The water inlet valve is a solenoid-operated switch that, when activated, releases water from the supply line to the water valve and into the compact icemaker mold. This valve is used on side by side or bottom mount refrigerators.

Easy Part #:: EAP11743551

Availability:: In Stock

Price:: $74.05

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:: EAP347819

Availability:: In Stock

Price:: $18.90

Electronic control board (electronic control)

This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.

Easy Part #:: EAP11755733

Availability:: In Stock

Price:: $148.39

Crisper glass (glass crisper)

Glass Only. Frame sold separately.

Easy Part #:: EAP11743718

Availability:: In Stock

Price:: $117.65

Ice bucket (ice pan)

The ice bucket is used to hold the ice cubes in the freezer section that are released from the ice maker until ready to be used. If the bin becomes lost or damaged, you will need to replace the bin. The bin is white in color, made of plastic, and measures approximately 15” x 12”. This is a genuine OEM part.

Easy Part #:: EAP11743447

Availability:: In Stock

Price:: $78.37

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Easy Part #:: EAP11743313

Availability:: In Stock

Price:: $53.34

Humidity control slide (slide)

This part mounts on the crisper drawer cover and is used to limit the amount of air that gets into the crisper.

Easy Part #:: EAP11743638

Availability:: In Stock

Price:: $10.33

Freezer evaporator fan motor - 115v 60hz (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will covert the heat into cool air, which is then circulated.