59676593602 Kenmore Refrigerator Parts List

Pantry drawer glide - left or right side (glide pantry)

Mounting screws not included.

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Pantry drawer (drawer pantry)

Damper control assembly (control)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Screw

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Frame screw (screw)

Sold Individually.

Water tube connector/union - 5/16 to 5/16 (fitting)

Sold Individually. - * Part may differ in appearance, but functions same as original.

Water filter backing plate (plate, filte)

Screw

This screw is sold individually

Water filter cover (filter cover)

This part is the replacement water filter cover for your refrigerator. It is made of white plastic and is approximately 13 inches long and 4 inches wide at the widest point. The water filter cover protects the water filter from damage while it is installed in the refrigerator. The main reason to replace the water filter cover is if it is cracked, damaged, or missing. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Plastic tubing (tubing)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Bimetal defrost thermostat (bimetl-def)

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Verticle mullion rail - apollo gray (vert mulli)

Single wheel assembly (cabinet roller)

This wheel is sold individually - purchase quantity needed.

Ice maker wire harness (wire harness)

This part connects to the electrical and allows power to flow through your appliance.