59678289802 Kenmore Refrigerator Parts List

Freezer evaporator fan motor - 115v 60hz (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will covert the heat into cool air, which is then circulated.

Refrigerator door gasket (gasket panel)

This door gasket is for refrigerators. The door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the refrigerator. Safely store any food that could deteriorate while the door is open for this repair.

Door shelf bin (cantilever bin)

Sold individually.

Refrigerator compressor start relay (start-dev)

This compressor start relay is for refrigerators. The compressor start relay attaches to the compressor and helps start the compressor motor. Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part.

Damper control assembly (control)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Kickplate grille (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Touch-up paint - black (tuchup)

16ml

Bimetal defrost thermostat (bimetl-def)

This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Door gasket - black (gasket panel)

Motor-cond fan,115vac 1090rpm (motor-cond)

This is a condenser fan motor for your refrigerator/freezer. This fan motor is most commonly used with frost-free refrigerators with a condenser coil. It controls the rotation of the condenser fan blade. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This fan motor also helps to evaporate excess water in the drain pan. This model is all white in color, and is roughly 4 inches long, 3 inches wide, and 3.5 inches thick.

Single wheel assembly (cabinet roller)

This wheel is sold individually - purchase quantity needed.

Levelling foot (brake foot)

Icemaker (ice maker)

This kit comes with the icemaker, bucket, valve, tubing and necessary hardware for replacement.

Adhesive cement (adhesive)

Also known as Alumilastic Cement.

Hinge-door (door hinge)