59679522012 Kenmore Refrigerator Parts List

Electronic control board (electronic control)

This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

P-trap drain tube kit (drain tube)

Also known as a duck bill. This kit includes the tube extension piece and spacer.

Freezer evaporator fan motor - 115v 60hz (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will covert the heat into cool air, which is then circulated.

Refrigerator door gasket (gasket panel)

This door gasket is for refrigerators. The door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the refrigerator. Safely store any food that could deteriorate while the door is open for this repair.

Door shelf bin (cantilever bin)

Sold individually.

Vertical mullion rail - white (vert mulli)

White in color.

Freezer door gasket - black (gasket panel)

This door gasket is used to seal the freezer door when closed.

Kickplate grille - white (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Frame

Freezer door gasket - white (door gasket)

The freezer door gasket is white in color.

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Damper control assembly (control)

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Pan-ice (ice pan)

Touch-up paint - black (tuchup)

16ml