5967954201 Kenmore Refrigerator Parts List

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Refrigerator water filter bypass (bypass)

This cap is used when bypassing the filter.

Pivot block

This is a replacement pivot block for your refrigerator. It is made of white plastic and is approximately 4 inches long and 1 inch wide. The pivot block catches and holds the door mullion cover when you close the door. If your refrigerator door will not close properly, you may need to replace the pivot block. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Cycling thermostat (refrigerator ice maker thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Freezer door gasket - apollo gray (gasket panel)

This door gasket is used to seal the freezer door when closed. It is compatible with Bottom freezer.

P-trap drain tube kit (drain tube)

Also known as a duck bill. This kit includes the tube extension piece and spacer.

Main electronic control board (electronic control)

Water filter cover (lid, water f)

This part is the replacement water filter cover for your refrigerator. The cover protects the water filter to prevent damage. If the water filter cover is cracked or missing, you should replace it. It is made of white plastic and is approximately 12 inches long, 5 inches wide at one end, and 4 inches wide at the other. To replace the water filter cover, simply depress the locking tabs and remove the old cover, then snap the new cover into place. This part is sold individually.

Humidity control slide (refrigerator crisper drawer humidity control)

This part mounts on the crisper drawer cover and is used to limit the amount of air that gets into the crisper.

Door shelf bin - gallon (cantilever bin)

Measures 7.5 deep x 14 wide x 3.5 high. Sold individually.

Water inlet valve (refrigerator water inlet valve)

This part releases water from the supply line when it's activated.

Door shelf bin (refrigerator door bin)

Sold individually.

Ice bucket and auger assembly (ice bin)

This assembly includes the bin, auger and blades.

Drawer gear kit (gear)

These parts will attach to your drawer rail and are used to help the drawer glide smoothly.

Refrigerator compressor start relay (start-dev)

This compressor start relay is for refrigerators. The compressor start relay attaches to the compressor and helps start the compressor motor. Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part.