59695508200 Kenmore Refrigerator Parts List

Cycling thermostat (thermostat (also order r0195019 cement alumilastic))

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Compression nut (nut-sleeve inlet)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Fresh food door gasket (gasket-door, white (used on 55082 and 55088))

This white fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Crushed ice bucket (bucket)

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.

Screw (screw-mach hinge cover)

Sold individually.

Crushed ice wheel (wheel-crushed ice lift)

This crushed ice wheel is five inches in diameter. It is beige in color and is made of plastic.

Kickplate grille with clips (grille-toe, white)

White in color.

Single hex head screw (screw-small drain tube clamp (4))

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Ice stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Freezer door gasket (gasket-door, white (used on 55802 and 55088))

This door gasket is approximately sixty-one and a half inches long and fourteen and a half inches wide. It is all white in color and it is made entirely of rubber. This gasket is used for the freezer of door of some side by side refrigerators.

Screw (screw small (6))

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Screw kit (screw-tf., top hinge assembly (3))

Includes 2 screws.

Screw (screw-small (7))

This screw is sold individually

Plastic tubing (tube-plastic)

The water supply tubing is made of plastic and goes between the water inlet valve and the ice maker inlet tube. The tubing is 8 1/2 feet long and 1/4” in diameter. The water supply tubing transports water to the ice and water dispensers. If there is no water going to the ice maker, the refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace the water supply tubing. This is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Defrost heater (heater-defrost)