62260002600 Kenmore Range Parts List

Terminal block

The terminal block provides a way of connecting individual electrical wires and offers protection from electrical surges, voltages and currents. This part will also allow you to attach the power cord to the inner wiring of your range. If the terminal block has shorted out or the range is not getting the proper power, this part will need to be replaced. The nuts are not included with the terminal block, they must be ordered separately. This is a genuine OEM part. Please remember to disconnect the power to the range before starting the repair.

Infinite switch - 6 inch (infinite switch)

Screw

Oven rack

Sold individually.

Anti-tip bracket (bracket)

Sold individually.

Elmnt-surf (triple element)

Door hinge - left or right side (oven hinge)

Sold individually.

Screw

Sold Individually.

Screw

Sold individually.

Round snap nut - black (nut, snap (1)

Oven light

The oven light provides light in the oven cavity. The light assembly is a little over four inches long and has a 660-watt light bulb. If the light is not turning on, the bulb may be burnt out or the socket has failed and will need to be replaced. This is a genuine OEM part.

Stand mixer screw (screw)

This screw is sold individually.

Infinite switch - 8 inch (switch element)

Sold individually.

Door glass bottom support - white (trim, door bottom (white))

This part helps support the oven glass.

Dual surface burner switch (switch element)

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.