62946775690 Kenmore Range Parts List

Range surface element (element w/limiter (dual))

Elmnt-surf (element w/limiter (8"))

Screw (screw, trim (blk))

Sold Individually.

Screw (screw, trim (wht))

Sold individually.

Round snap nut - black (nut, snap (1/8"))

Rear drawer support clip (support, drawer (rear))

This rear drawer support clip is an inch long. It is all black in color and is made entirely of plastic.

Storage drawer wheel and shaft (roller, drawer)

This wheel and shaft is used to open and close the bottom storage drawer of a range/stove.

Stand mixer screw (screw, lever)

This screw is sold individually.

Door hinge - left or right side (hinge, oven door)

Each hinge is sold seperately.

Dual surface burner switch (switch, element (dual))

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.

Indicator light lens (lens, indicator light)

Sold individually.

Screw - 6-32 x 5/16 (screw, support)

This screw is well under an inch long, and is made of metal.

Screw - white (screw, insert (wht))

This screw is sold individually.

Indicator light (light, indicator)

Door hinge kit (hinge, door)

This oven door hinge assembly comes with two screws and is intended for use with many ovens. It can be used on either the left or right hand side.