66515997499 Kenmore Dishwasher Parts List

Cover screw (screw)

Sold individually.

Door spring (dishwasher door spring *for heavy duty springs check recommended parts)

Sold individually.

Upper spray arm mount (upper washarm support mount. Note this will not be required with new style upper washarm support.)

This part is used to mount the spray arm to the upper dish rack.

Middle wash arm tube holder (holder, middle wash arm tube)

This holder should have a split in the ring at 3 o'clock position.

Dishrack clip

Sold Individually.

High limit thermostat (dishwasher high-limit thermostat.)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Upper wash assembly (upper spray assembly. *original may have two screw holes, only one needed now.)

NOTE: *Original may have two screw holes, only one screw is needed now.

Detergent dispenser (dishwasher detergent and rinse dispenser. *new design by manufacturer, rinse aid sensor no longer used.)

This part releases the detergent and rinse aid into the dishwasher. **Note** this part has been redesign by manufacturer, may look and function differently than original. Rinse aid cap is NOT included. Cap is no longer needed.

Screw - 8-18 x 5/8 (screw, 8-18 x 5/8)

Sold individually.

Door switch kit (dishwasher door switch repair kit. This door switch prevents the dishwasher from running while the door is open.)

This kit comes with 2 micro switches and a wire harness.

Drain hose with connector ends (drain hose assembly, 79 inches)

This hose is used to drain the water into your sink.

Drain check valve with o-ring (dishwasher check valve. This check valve prevents water from returning to the dishwasher after it has drained. If the valve gets stuck closed, it will)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Pump tub gasket (main tub seal at bottom of dishwasher around pump housing)

Complete pump seal kit (seal kit complete, rubber rings, fiber gasket)

This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.