66513169K702 Kenmore Dishwasher Parts List

Toe panel insulation (shield)

Drain hose

This is a flexible drain hose that is 12 feet long.

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Diverter motor with wire harness (motor-divrtr)

NOTE: This part has been updated by the manufacture and the shaft seal is now incorporated into the sump housing. The seal for diverter motor shaft only available with the pump sump housing.

Hinge-door (door hinge)

Screw

This screw is sold individually.

Dishwasher rinse-aid dispenser cap (cap)

Screw

This part is a replacement screw for your dishwasher. It is made of metal and is approximately ¾ inch long. It is a hex-head screw and is sold individually. It is used to hold the dispenser bracket in place. This part is a genuine OEM part sourced directly from the manufacturer.

Float switch (overflow switch)

Water that fills your dishwasher lifts the float. When it reaches a certain level, the float triggers this float switch to shut off, thereby shutting off the flow of water into the dishwasher.

Door hinge - right side (door hinge)

Air vent gasket (gasket)

Gasket

Also known as a washer.

Tine retainer (retainer)

Used on the lower dishrack.

Screen filter (screen)

Electronic control board (electronic control)

Also known as the "brains" of the appliance.