66513173K705 Kenmore Dishwasher Parts List

High limit thermostat (dishwasher high-limit thermostat.)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Inlet fill hose (water fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Screw - 8-18 x 5/8 (screw, 8-18 x 5/8)

Sold individually.

Door latch and switch assembly (dishwasher door latch and switch assembly)

Handle NOT included. This door latch with the switches is a simple on/off mechanism that prohibits the dishwasher from operating when the door is open.

Elbow hose fitting (dishwasher water inlet fitting. Has standard 3/4 inch hose thread on one end and 3/8 inch copper tubing on the other. Copper tubing fitting is compres)

This part has a swivel gooseneck fitting and that allows it to be installed closer to the wall. This part has a 3/4" hose thread on one side and a 3/8" copper tubing on the other side.

Door switch kit (dishwasher door switch repair kit. This door switch prevents the dishwasher from running while the door is open.)

This kit comes with 2 micro switches and a wire harness.

Turbidity sensor (turbidity sensor mounted in pump sump under dishwasher)

Measures level of soil in the water.

Spray arm (lower spray arm assembly)

This is a replacement spray arm for your dishwasher. It is approximately 20 inches wide. This spray arm is made of gray plastic and is sold individually. The spray arm rotates and sprays water to clean your dishes. The spray arm can occasionally become clogged and damaged, and this can prevent your dishes from being cleaned properly. To replace the spray arm, turn clockwise to release, and attach the new arm by connecting it to the nozzle and turning counter clockwise. This is an authentic OEM part.

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Tub cap (plug, tub)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Water inlet (water inlet into dishwasher)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Dishwasher tub sound shield (sound shield)

The tub sound shield insulates the tub to reduce noise.

Float switch kit

This kit includes the switch, lever, seal and standpipe. Water that fills your dishwasher lifts the float, and when it reaches a certain level, the float acts as a trigger for the float switch. The float triggers the switch to shut off, thereby shutting off the flow of water into the dishwasher.

Dishwasher screw (screw)

Sold individually.

Toe panel insulation (shield)