66513212K902 Kenmore Dishwasher Parts List

Heating element (heater)

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Non-flip clip (clip)

Sold individually.

Upper dishrack (dishrack)

Wheels NOT included.

Accumulator and filter (accumulator)

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Tub cap (cap)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Touch-up paint - black (tuchup)

16ml

Spring grip retainer (terminal nut)

Water inlet (water inlet valve)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Screw (handle screw)

This screw is sold individually.

Clip

This OEM dishrack guard clip fits on the front of the upper dishrack and acts as a bumper between the rack and inner door panel. This guard clip is approximately 3 inches long and made of plastic. To replace this part, open the dishwasher door and then slide the upper dishrack out, then simply unclip the faulty guard clip before fastening the new one.

Dishwasher tub sound shield (shield)

The tub sound shield insulates the tub to reduce noise.

Protector (protector cover)

This part is used to cover the chopper blades.

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.

Toe panel insulation (shield)