66513612100 Kenmore Trash Compactor Parts List

Grease (grease, 4 oz. (use on power screw and ram pressure pads) (accessory parts may or may not be included with your compactor))

Drawer tilt switch (switch, drawer safety)

Clip (clip, ring)

This clip is used with trash compactors, in the motor and drive section. This clip is sold individually.

Latch-plt (plate, latch)

Bearing plate (plate, bearing (2))

Washer (washer, wave)

Spring pin (pin, slotted spring)

This spring pin is used on trash compactors. This part works in conjunction with the drive gear that attaches to the bottom of the drive motor of the trash compactor. If your compactor ram is getting stuck, there is excess noise during its cycle, or if your compactor does not stop at the end of its cycle, the driving gear and/or spring pin may be the issue.

Insert (insert, escutcheon white)

Switch knob - almond (knob, switch biscuit)

Nut - 5/8-11 x .547 hx (nut, power screw (2))

Escutcheon (escutcheon, control biscuit)

Knob-swich (knob, switch graphite)

Drawer slide - left side (slide, frame (l.H.))

This drawer track supports the left hand side of the sliding drawer.

Safety switch actuator (actuator, safety switch)

This part is used in conjunction with trash compactors by connecting to the drawer frame and activates the safety switch when the drawer is closed.

Handle (handle, container black)