66513873K602 Kenmore Dishwasher Parts List

Spray arm seal (bearing)

Also known as a wash arm seal.

Upper wheel gasket (wheel and mount gasket)

Sold individually.

Screw - 8-18 x 1/2 (screw)

Sold Individually.

Rinse aid cap (cap)

This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.

Screw

Sold individually.

Seal

This seal is attached to the inner cabinet to reduce noise.

Spray arm seal (seal)

This seal is located between the spray arm and the water feed tube.

Terminal nut

Cover screw (screw)

Sold individually.

Drain hose

This drain hose is 6 and 1/2 feet.

Electronic control board

This board is located in the control panel of the dishwasher.Thermal fuse is NOT included.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

High limit thermostat (thermostat)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Sump and motor assembly (pump motor)

This part moves water up from the sump collection area and up through the spray arms.

Impeller (seal)

This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.