66513973K014 Kenmore Dishwasher Parts List

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Adjuster arm clip (clip)

Sold individually.

Screw - 8-18 x 5/8 (screw #8-18)

Sold individually.

Inlet fill hose (fill hose)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Turbidity sensor (sensor)

Measures level of soil in the water.

Side mounting bracket kit (mounting bracket)

This mounting kit can be used on solid surface countertops.

Shield (panel)

Shield

Upper rack wheel (wheel-uper)

Sold individually.

Overfill control switch (switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Tub cap (cap)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Touch-up paint - black (tuchup)

16ml

Spring grip retainer (terminal nut)

Water inlet (water inlet valve)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Clip

This OEM dishrack guard clip fits on the front of the upper dishrack and acts as a bumper between the rack and inner door panel. This guard clip is approximately 3 inches long and made of plastic. To replace this part, open the dishwasher door and then slide the upper dishrack out, then simply unclip the faulty guard clip before fastening the new one.