66514763N510 Kenmore Dishwasher Parts List

Seal (dishwasher tub gasket)

This seal is attached to the inner cabinet to reduce noise.

Adjuster housing cover (dishwasher dishrack adjuster cover)

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components of the adjuster housing.

Cover screw (range screw)

Sold individually.

Water inlet valve (dishwasher water inlet valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Clip (dishwasher dishrack guard clip)

Door spring (dishwasher door spring)

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adjuster arm clip (dishwasher dishrack adjuster arm positioner clip)

Sold individually.

Screw - 8-18 x 5/8 (dishwasher screw)

Sold individually.

Inlet fill hose (dishwasher water inlet tubing)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Adjuster housing - left hand (dishwasher dishrack adjuster housing, left)

This is the replacement adjuster housing for your dishwasher. It is made of gray plastic and is approximately 4X4 inches. The adjuster housing clips into the dish rack and allows you to adjust the height of the rack. Because it is made of plastic, the housing can occasionally break. When this happens you may notice that one side of your dish rack is lower than the other. If the housing is damaged, you will not be able to properly adjust the dish rack height. This is an authentic OEM part sourced directly from the manufacturer and is sold individually.

Adjuster housing - right hand (dishwasher dishrack adjuster housing, right)

Overfill control switch (dishwasher float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Dishwasher tub sound shield

The tub sound shield insulates the tub to reduce noise.

Thermostat (dishwasher thermostat)