66514793N512 Kenmore Dishwasher Parts List

Hose clamp

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adjuster arm clip (dishwasher dishrack adjuster arm positioner clip)

Sold individually.

Screw - 8-18 x 5/8 (dishwasher screw)

Sold individually.

Inlet fill hose (dishwasher water inlet tubing)

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Adjuster housing - left hand (dishwasher dishrack adjuster housing, left)

This is the replacement adjuster housing for your dishwasher. It is made of gray plastic and is approximately 4X4 inches. The adjuster housing clips into the dish rack and allows you to adjust the height of the rack. Because it is made of plastic, the housing can occasionally break. When this happens you may notice that one side of your dish rack is lower than the other. If the housing is damaged, you will not be able to properly adjust the dish rack height. This is an authentic OEM part sourced directly from the manufacturer and is sold individually.

Motor (dishwasher diverter motor)

Also know as a diverter valve. This diverter motor is for dishwashers. Diverter motor controls the flow of water to the spray arms. Unplug the dishwasher and shut off the water supply before installing this part. Wear work gloves to protect your hands.

Door latch - black (dishwasher door latch)

Upper spray arm (dishwasher spray arm)

The upper spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If your dishes are not being cleaned properly, you should check if there is an issue with the spray arm. To check your spray arm, make sure the spray arms can move evenly and freely on their bearing rings and mounting brackets. Remove your spray arm and check to ensure they are straight and undamaged. This spray arm is made of high-quality plastic and is just over 5 inches long.

Grommet (dishwasher pump grommet)

Side mounting bracket kit (dishwasher side mounting bracket kit)

This mounting kit can be used on solid surface countertops.

Screen (dishwasher filter)

Adjuster housing - right hand (dishwasher dishrack adjuster housing, right)

Access panel (black) (dishwasher access panel)

This part conceals and protects components located beneath the dishwasher tub.

Overfill control switch (dishwasher float switch)

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw (appliance screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".