66514799N511 Kenmore Dishwasher Parts List

Inlet fill hose

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Adjuster housing - left hand

This is the replacement adjuster housing for your dishwasher. It is made of gray plastic and is approximately 4X4 inches. The adjuster housing clips into the dish rack and allows you to adjust the height of the rack. Because it is made of plastic, the housing can occasionally break. When this happens you may notice that one side of your dish rack is lower than the other. If the housing is damaged, you will not be able to properly adjust the dish rack height. This is an authentic OEM part sourced directly from the manufacturer and is sold individually.

Door latch - black

Upper spray arm

The upper spray arm rotates and sprays water to clean the dishes inside the dishwasher tub. If your dishes are not being cleaned properly, you should check if there is an issue with the spray arm. To check your spray arm, make sure the spray arms can move evenly and freely on their bearing rings and mounting brackets. Remove your spray arm and check to ensure they are straight and undamaged. This spray arm is made of high-quality plastic and is just over 5 inches long.

Grommet

Turbidity sensor

Measures level of soil in the water.

Side mounting bracket kit

This mounting kit can be used on solid surface countertops.

Screen

Adjuster housing - right hand

Access panel (black)

This part conceals and protects components located beneath the dishwasher tub.

Overfill control switch

This part is also known as a float switch. This float switch, when activated, stops the flow of water into the dishwasher.

Single hex head screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Drain pump

Tub cap

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Sump

This works in conjunction with the pump and filtration system. It is used to receive drainage for disposal.