66514813N610 Kenmore Dishwasher Parts List

Upper dishrack

Rack only.

Seal

This seal is attached to the inner cabinet to reduce noise.

Adjuster housing cover

The adjuster cover goes on the outside of the adjuster housing. It is used to support the height adjuster and also protects the internal components of the adjuster housing.

Drain hose

This drain hose is 6 and 1/2 feet.

Cover screw

Sold individually.

Water inlet valve

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Clip

Door spring

This dishwasher door spring is sold individually. It is recommended if you are replacing one side, to replace both.

Spray paint - 12 oz. - white

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Push-in retainer clip

Sold individually.

Hose clamp (use wpl 285655)

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Adjuster arm clip

Sold individually.

Screw - 8-18 x 5/8

Sold individually.

Inlet fill hose

This fill hose is a genuine OEM replacement part for your dishwasher. The hose is made of black plastic, and is accordion-style, for ease of movement within your dishwasher. To replace the fill hose, you will need a 1/4 inch nut driver, Channellock pliers, and a Phillips screwdriver. Replacing this part will require some disassembly, such as removing the water inlet valve from the fill hose, and the clamps which secure the hose in place. Reuse your existing clamps when securing your new fill hose in place.

Adjuster housing - left hand

This is the replacement adjuster housing for your dishwasher. It is made of gray plastic and is approximately 4X4 inches. The adjuster housing clips into the dish rack and allows you to adjust the height of the rack. Because it is made of plastic, the housing can occasionally break. When this happens you may notice that one side of your dish rack is lower than the other. If the housing is damaged, you will not be able to properly adjust the dish rack height. This is an authentic OEM part sourced directly from the manufacturer and is sold individually.