6651544591 Kenmore Dishwasher Parts List

Impeller

This kit contains Impeller and Bearing Assembly.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Drain hose with connector ends (drain hose)

This hose is used to drain the water into your sink.

Water inlet valve - 120v (water inlet valve)

This water inlet valve is intended for use with horizontal motor dishwashers. It uses a 3/8 of an inch valve tubing and a mounting bracket.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door latch bolt (latch and latch bolt)

Touch-up paint - black (tuchup)

16ml

Tub sound shield - insulation (sound shield)

Tine tips (tine tip repair kit)

Have to be installed with adhesive which is sold separately.

Toe panel with insulation (toe panel)

Located at the bottom.

Hose clamp

This clamp helps to prevent leaking by holding the end of water hose in place.

Upper dishrack roller assembly (wheel)

The light gray upper roller and clip attach to the upper rack to allow the dishrack to move in and out along the track of the dishwasher. If your dish rack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The roller and axel is made of plastic and measures 1 1/2” W x 2 1/2” high x 1” deep. This is a genuine OEM part and is sold separately.

Door panel retainer strip - black (retainer)

Pump housing kit (housing)

This is the pump housing only.