6651570992 Kenmore Dishwasher Parts List

Upper track end cap (end cap (front or rear))

This part goes at the end of the rail to stop the dishrack from falling out.

Upper wash arm support clip (clip)

Cycling thermostat - l150-25f (light, indicator (for electrical connector only, see wiring harness page.))

This thermostat controls the internal drying temperature. Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature. This particular cycling thermostat has a limit of 150 degrees Fahrenheit and a differential of 25 degrees. Meaning that with this thermostat, the heating element will cut out at 150 degrees and cycle back on once the internal temperature drops by 25 degrees.

Seal, inlet base

Upper spray arm tower (tower, pressure)

Lower dishrack wheel (wheel & transport assembly (4))

Sold Individually.

Access panel insulation with glue (sound shield)

This piece of insulation goes behind the very bottom access panel of the dishwasher. This insulation helps reduce the noise produced by the dishwasher when it is in use.

Ball, check

Spray arm, upper (also order i (spray arm, upper)

This part includes the spray arm, support and clip.

Water inlet valve (valve, water inlet)

This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Door gasket (gasket, tub)

It provides a seal between the tub and the door.

Hose clamp (clamp, hose)

Door spring retainer with protective tip (retainer, spring (2) (includes item 54))

This part holds the door spring to the frame.

Terminal (terminal, male (round pin))

Silverware basket

This is a basket for washing flatware or silverware in your dishwasher.