66515725690 Kenmore Dishwasher Parts List

High limit thermostat (thermostat, hi-limit)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Dishrack (dishrack, upper)

Access panel (panel, access)

This part is located on the bottom.

Water deflector (deflector (2))

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Screw - 8-18 x 5/8 (screw, 8-18 x 5/8)

Sold individually.

Door switch kit (switch (2))

This kit comes with 2 micro switches and a wire harness.

Drain hose with connector ends (hose, drain)

This hose is used to drain the water into your sink.

Drain check valve with o-ring (check valve (includes item 6))

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Water inlet valve - 120v (water valve)

This water inlet valve is intended for use with horizontal motor dishwashers. It uses a 3/8 of an inch valve tubing and a mounting bracket.

Door spring (spring (draw bar))

These detergent cup dispenser springs are sold individually.

Pump outlet seal (seal, pump outlet)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Door latch bolt (bolt, latch)

Nozzle cap (cap, nozzle)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Screw (screw, 10-16 x 1/2 (4))

This screw is sold individually.

Pump tub gasket (gasket, pump)