66515764000 Kenmore Dishwasher Parts List

Rinse aid cap (cap, wet-agent)

This cap does not require the use of a o-ring seal.

Pin (lid hinge)

The lid hinge pin or detergent lid pin on your dishwasher helps dispense your dish detergent when your dishwasher is running. The pin fits with the dispenser lid and allows the lid to pop open and dispense detergent. It is a small, plastic pin that is approximately 3 inches in length. Due to its small size, the pin can be damaged relatively easily, and if your pin is broken or missing, it will need to be replaced. This product is sold individually.

Screw - 8-18 x 1/2 (screw)

Sold Individually.

Soap dispenser cover (lid assembly)

This part covers your soap dispenser and is spring loaded.

Screw

Sold individually.

Terminal nut (nut (2) (heater terminal))

Thermal fuse and harness (fuse, thermal)

*Please Note - When changing the fuse always use a new wiring harness.

Soap cup latch kit (latch, detergent dispenser (includes item 3))

The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.

Upper spray arm mount (mount, upper sprayarm)

This part is used to mount the spray arm to the upper dish rack.

Spray paint - 12 oz. - white (paint, pressurized spray (12 oz.) white)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Manifold (tube, manifold)

This part connects the spray arm to the main water tube. Also known as a water supply tube. Note: This part has been updated from the original.

High limit thermostat (thermostat, hi-limit)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Wheel assembly (wheel and transport assembly)

Sold Individually - 4 required on rack.

Upper wash assembly (wash assembly w/slinger)

NOTE: *Original may have two screw holes, only one screw is needed now.

Water deflector (deflector (2))

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.