66515828692 Kenmore Dishwasher Parts List

Soap cup latch kit (latch kit)

The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.

High limit thermostat (thermostat)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Dishrack

Water deflector (deflector)

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Screw - 8-18 x 5/8 (screw #8-18)

Sold individually.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Drain hose with connector ends (drain hose)

This hose is used to drain the water into your sink.

Drain check valve with o-ring (valve kit)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Pump outlet seal (seal)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Nozzle cap (cap)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Pump tub gasket (gasket)

Float-assembly (float assembly)

This float assembly comes with the nut.

Touch-up paint - black (tuchup)

16ml