6651586581 Kenmore Dishwasher Parts List

Drain check valve with o-ring (valve, check (includes illus. 21 & 23))

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Pump outlet seal (seal, pump outlet)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Pump tub gasket (gasket, pump)

Complete pump seal kit (pump seal kit (includes illus. 4, 13 & 22))

This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.

Tub sound shield - insulation (shield, sound)

Knob spring-clip (clip, knob)

Also known as the inside sleeve for the knob to be able to properly fit over the shaft of the switch. Sold individually.

Hose clamp (clamp, hose)

This clamp helps to prevent leaking by holding the end of water hose in place.

Power cord kit (power cord kit (optional))

Includes power cord and all necessary parts needed for complete installation of cord.

Door gasket and flange kit (gasket, tub)

This dishwasher door gasket and flange kit comes with a white door gasket, a flange, ten screws, and an instructions sheet.

Lower wash arm bearing (bearing, nozzle)

Pump housing centering tool (tool, pump centering)

Cap and connector assembly (cap, nozzle)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Screw (screw, 8-18 x 1/2 phlps. Oval hd. W/cup wshr. Tapping (4))

Sold individually.

Leveling leg (leg, leveler (2))

Leveling leg Now includes two different sizes. Use the one for your model. If you need two legs you will need to purchase a QTY of two of this kit.

Upper wash arm support clip (clip)