6651595840 Kenmore Dishwasher Parts List

Leveling leg (leg, leveler (2))

Leveling leg Now includes two different sizes. Use the one for your model. If you need two legs you will need to purchase a QTY of two of this kit.

Cap and connector assembly (cap, nozzle)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Screw (screw, 10-32 x 5/16 hex wshr. Hd. Mach. (2))

Sold individually.

Upper spray arm tower (tower, pressure)

Upper wash arm support clip (clip)

Transformer screw (screw, 8-18 x 1/2 (2))

This screw is sold individually.

Seal, inlet base

Access panel insulation with glue (shield, sound)

This piece of insulation goes behind the very bottom access panel of the dishwasher. This insulation helps reduce the noise produced by the dishwasher when it is in use.

Ball, check

Spray arm, upper (also order i (spray arm (upper))

This part includes the spray arm, support and clip.

Water inlet valve (valve, water inlet 303650 (alt.) 300453 (alt.))

This water inlet valve is intended for use with under counter style dishwashers. It has a 3/8 of an inch FPT (female pipe thread) valve and a mounting bracket. - This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Terminal (terminal, female (used with illus. 13 only))

Hose clamp (clamp, hose)

Door spring retainer with protective tip (retainer spring (2) (includes illus. 67))

This part holds the door spring to the frame.

Terminal (terminal, male (round pin))