66516273400 Kenmore Dishwasher Parts List

Dishrack adjuster housing (cover, adjuster)

This housing comes in two pieces, and with two screws.

Upper wash arm mount (mount)

Light gray in color.

Drain pump- 60hz 120v (pump, drain)

The drain pump ejects the water from the dishwasher.

Axle adjuster (axel, adjuster)

This part is a replacement axle adjuster for your dishwasher. It is made of white plastic and is approximately ¾ of an inch long and ½ an inch wide. The axle adjuster attaches to the dishrack roller bracket and allows the roller to turn. If the axle is damaged or missing, the rollers will not turn, and it will be difficult to roll your dishrack in and out effectively. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Air inlet (inlet, air)

This part is located at the bottom of the door. It helps to circulate air during the drying process.

Heating element (heater element assembly (also includes item 2))

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Access panel (black) (access panel (includes item 7) (black))

This part conceals and protects components located beneath the dishwasher tub.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Accumulator and filter (accumulator assy)

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Tub cap (plug tub (2))

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Spring grip retainer (retainer, spring grip)

Water inlet (water inlet (also order item 4))

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Dishwasher tub sound shield (shield, sound tub)

The tub sound shield insulates the tub to reduce noise.

Protector (protector, inlet)

This part is used to cover the chopper blades.

Float switch kit (standpipe, overfill (also includes item 13))

This kit includes the switch, lever, seal and standpipe. Water that fills your dishwasher lifts the float, and when it reaches a certain level, the float acts as a trigger for the float switch. The float triggers the switch to shut off, thereby shutting off the flow of water into the dishwasher.