66516299402 Kenmore Dishwasher Parts List

Drain hose (loop drain)

This hose is used to drain the water.

Kickplate - black (toe panel)

New Black Single Metal Access Panel Replacement Kit. Replaces old two part toe kick plates. Reuse insulation off old panel or see Recommended Parts.

Dishrack adjuster housing (adjuster)

This housing comes in two pieces, and with two screws.

Upper wash arm mount (mount)

Light gray in color.

Drain pump- 60hz 120v (drain pump)

The drain pump ejects the water from the dishwasher.

Axle adjuster (axle rack)

This part is a replacement axle adjuster for your dishwasher. It is made of white plastic and is approximately ¾ of an inch long and ½ an inch wide. The axle adjuster attaches to the dishrack roller bracket and allows the roller to turn. If the axle is damaged or missing, the rollers will not turn, and it will be difficult to roll your dishrack in and out effectively. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Air inlet

This part is located at the bottom of the door. It helps to circulate air during the drying process.

Heating element (heater)

This dishwasher heating element is not designed to heat the water that enters it, but is designed to maintain the heat of the water that enters the dishwasher. It is located on the bottom of the dishwasher.

Access panel (black) (panel)

This part conceals and protects components located beneath the dishwasher tub.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Non-flip clip (clip)

Sold individually.

Accumulator and filter (accumulator)

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Tub cap (cap)

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Touch-up paint - black (tuchup)

16ml

Spring grip retainer (terminal nut)