66517422990 Kenmore Dishwasher Parts List

Dishrack

Water deflector (deflector)

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Heat resistant adhesive (adhesive)

This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising the integrity of the adhesive. It is white in color, and the tube is approximately 7.5 inches long.

Drain and fill hose assembly (fil&drnhos)

This part is used for portable dishwashers.

Impeller

This kit contains Impeller and Bearing Assembly.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Door latch bolt (latch and latch bolt)

Screw

This screw is sold individually.

Water inlet hose washer (4-pack of hose washers)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (tuchup)

16ml

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.

Tine tips (tine tip repair kit)

Have to be installed with adhesive which is sold separately.

Upper dishrack roller assembly (wheel)

The light gray upper roller and clip attach to the upper rack to allow the dishrack to move in and out along the track of the dishwasher. If your dish rack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The roller and axel is made of plastic and measures 1 1/2” W x 2 1/2” high x 1” deep. This is a genuine OEM part and is sold separately.