66517432001 Kenmore Dishwasher Parts List

Terminal nut (nut (2) (heater terminal))

Soap cup latch kit (latch, detergent dispenser (includes item 3))

The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.

Spray paint - 12 oz. - white (paint, pressurized spray (12 oz) white)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Wheel assembly (wheel and transport assembly (4))

Sold Individually - 4 required on rack.

Dishrack (dishrack, upper)

Water deflector (deflector (2))

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Drain and fill hose assembly (coupler assembly)

This part is used for portable dishwashers.

Impeller (impeller and bearing assembly)

This kit contains Impeller and Bearing Assembly.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Door switch kit (switch (2))

This kit comes with 2 micro switches and a wire harness.

Door spring (spring (draw bar))

These detergent cup dispenser springs are sold individually.

Door latch bolt (bolt, latch)

Screw (screw, 10-16 x 1/2 (4))

This screw is sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (paint, touch-up (1/2oz) bisque/biscuit)

16ml