Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.
This kit contains Impeller and Bearing Assembly.
This screw is sold individually.
This kit comes with 2 micro switches and a wire harness.
These detergent cup dispenser springs are sold individually.
The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.
Have to be installed with adhesive which is sold separately.
The light gray upper roller and clip attach to the upper rack to allow the dishrack to move in and out along the track of the dishwasher. If your dish rack is not moving in and out of the dishwasher properly you may have a broken or missing wheel and it will need to be replaced. The roller and axel is made of plastic and measures 1 1/2” W x 2 1/2” high x 1” deep. This is a genuine OEM part and is sold separately.
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.
This is the pump housing only.
This screw is sold individually. Size: 8-32 x 1/4 inch.
Water that fills your dishwasher lifts this float, and when it reaches a certain level, it acts as a trigger for the float switch. The float triggers the float switch to shut off, thereby shutting off the flow of water into the dishwasher.