66517439000 Kenmore Dishwasher Parts List

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Wheel assembly (roller assembly)

Sold Individually - 4 required on rack.

Dishrack

Water deflector (deflector)

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Heat resistant adhesive (adhesive)

This is a heat-resistant adhesive for your appliance. The heat resistance allows you to stick parts such as grate feet, gaskets, and felt seals in hot areas, such as a cooktop, without compromising the integrity of the adhesive. It is white in color, and the tube is approximately 7.5 inches long.

Drain and fill hose assembly (fil&drnhos)

This part is used for portable dishwashers.

Impeller

This kit contains Impeller and Bearing Assembly.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Door latch bolt (latch and latch bolt)

Screw

This screw is sold individually.

Water inlet hose washer (4-pack of hose washers)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (tuchup)

16ml

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.