6651761590 Kenmore Dishwasher Parts List

High limit thermostat (thermostat)

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.

Dishrack

Water deflector (deflector)

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Screw - 8-18 x 5/8 (screw #8-18)

Sold individually.

Drain and fill hose assembly (fil&drnhos)

This part is used for portable dishwashers.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Drain check valve with o-ring (valve kit)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Pump outlet seal (seal)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Door latch bolt (latch and latch bolt)

Nozzle cap (cap)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Screw

This screw is sold individually.

Pump tub gasket (gasket)

Water inlet hose washer (4-pack of hose washers)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.