66517729K900 Kenmore Dishwasher Parts List

Soap cup latch kit (latch kit)

The latch kit includes the latch and the snap. This part is used to keep the soap dispenser cover closed until activated. It is located on the inside of the door panel on the right side. If your dishwasher is not dispensing detergent, or the latch is broken or damaged, you may need to replace the latch kit. This is a genuine OEM part.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Wheel assembly (wheel)

Sold Individually - 4 required on rack.

Water deflector (deflector)

This part is located in the lower front corners of the dishwasher tub. They keep the water away from the corners of the appliance and therefore eliminating the rush of water behind the door.

Drain and fill hose assembly (fil&drnhos)

This part is used for portable dishwashers.

Impeller

This kit contains Impeller and Bearing Assembly.

Screw, 8-18 x 1/2 (screw)

This screw is sold individually.

Door switch kit (switch kit)

This kit comes with 2 micro switches and a wire harness.

Door spring (spring)

These detergent cup dispenser springs are sold individually.

Door latch bolt (latch and latch bolt)

Screw

This screw is sold individually.

Touch-up paint - black (tuchup)

16ml

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.

Water inlet valve (inlet valve)

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Pump housing kit (housing)

This is the pump housing only.