66517742K013 Kenmore Dishwasher Parts List

Spring

This door spring is a genuine OEM replacement part for your dishwasher. The spring ensures that your dishwasher door does not fall open too quickly. If this occurs, one or both springs should be replaced. This part consists of one spring. To replace the spring, you will need to pull the dishwasher about six inches to a foot out from the cabinet. Replacing the spring has been rated as an easy repair by our customers.

Door latch bracket kit - no handle (latch bolt)

Handle is not included with this part.

Dishrack roller assembly (wheel)

Upper rack wheel and mount assembly (tub wheel)

This mount assembly attaches on either side of the inner cabinet wall for the upper rack. It glides over and under the the slide track.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Accumulator and filter (accumulator)

This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Door actuator (actuator)

This part is the door actuator for your dishwasher. It is made of black plastic and is approximately 3 inches long and 3 inches wide at its widest point. The door actuator is found in the control panel, and it releases the door latch when you lift the handle. If your current door actuator is cracked or broken, you may not be able to open your dishwasher door, or the door will not close properly. The dishwasher also may not be able to start, and if this is the case, you will need to replace it. This part is sold individually and is an authentic OEM part.

Screw

This screw is sold individually.

Touch-up paint - black (tuchup)

16ml

Water inlet (water inlet valve)

This is connected to the water valve, is located on the side of your tub and allows water to enter your dishwasher. ***Note: This part does not include the inlet gasket - must order separately.

Fil&drnhos (fil&frnhos)

Upper dishrack track (track)

This track attaches to the inside of the tub for the upper rack to glide in and out.

Protector (protector cover)

This part is used to cover the chopper blades.

Spray arm feed tube holder (holder)

This part holds the spray arm feed tube up.

Screw