6651777581 Kenmore Dishwasher Parts List

Drain check valve with o-ring (valve, check (includes illus. 21 & 23))

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed.

Pump outlet seal (seal, pump outlet)

This part is the replacement pump outlet seal or seal ring for your dishwasher. It is made of black rubber and is sold individually. The seal ring creates a seal between the upper compartment of the pump to the pump body. If the seal ring fails, you won’t have good water pressure, and therefore your dishes won’t come clean properly. Improperly cleaned dishes are a good indicator of a bad seal ring. Be sure to disconnect your dishwasher to the water and power sources before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Screw

This screw is sold individually.

Pump tub gasket (gasket, pump)

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Complete pump seal kit (pump seal kit (includes illus. 4, 12, 13 & 22))

This complete pump seal kit comes with four black rubber rings, a white fiber gasket, and a screw.

Door gasket and flange kit (retainer, r.H.)

This dishwasher door gasket and flange kit comes with a white door gasket, a flange, ten screws, and an instructions sheet.

Lower wash arm bearing (bearing, nozzle)

Pump housing centering tool (tool, pump centering)

Cap and connector assembly (cap, nozzle)

This new style nozzle cap has a rubber pressure seal attached. The rubber seal holds the lower spray arm down and in place.

Screw

Sold individually.

Fill hose - black (hose, inlet)

Upper wash arm support clip (clip)

Transformer screw (screw)

This screw is sold individually.