6657342403 Kenmore Trash Compactor Parts List

Trash compactor drawer assembly (container assembly)

Comes with drawer, frame, rollers and hardware.

Sprocket kit (sprocket tooth)

Latch-lock (latch assembly)

Used with trash compactors.

Washer (washer, thrust)

Screw (screw, 6-32x3/8)

Sold individually.

Clip (clip, ring)

This clip is used with trash compactors, in the motor and drive section. This clip is sold individually.

Latch-plt (plate, latch)

Bearing plate (plate bearing)

Washer (washer, wave)

Spring pin (pin, slotted spring)

This spring pin is used on trash compactors. This part works in conjunction with the drive gear that attaches to the bottom of the drive motor of the trash compactor. If your compactor ram is getting stuck, there is excess noise during its cycle, or if your compactor does not stop at the end of its cycle, the driving gear and/or spring pin may be the issue.

Arm-actuat (arm, actuator)

Nut - 5/8-11 x .547 hx (nut jam 5/8 x 11)

Drawer slide - left side (l.H.)

This drawer track supports the left hand side of the sliding drawer.

Washer power cord strain relief (bushing, power cord)

10-32 x .211 hf lser nut (locknut 10-32)