79070504012 Kenmore Range Parts List

Burner mounting screw (screw)

Sold individually.

Spark ignitor (module)

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in order to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

Spark ignition switch assembly with wire harness (igniter harness)

Four switches are included with the assembly.

Cap

Sold individually. This part helps the flame to spread for even heat. Also protects your burner head from spills.

Inner door glass (oven glass)

Oven bottom panel (bottom oven panel)

Surface burner orifice holder - left front 9.5k (ignitor orifice)

Wafer head screw (oven screw)

Screw

Sold Individually. Pan Head Screw - 8-18ab X 0.375

Sealed burner - 9.5k (burner)

Door hinge - left side (hinge)

Screw -8-18 x 1.438 (screw)

Insulation wrap (insulator)

Screw - 10-16 x .486 (screw)

This screw is for the drawer handle on a range or oven.

Door hinge (hinge)

Sold individually.