79072408012 Kenmore Range Parts List

Glide

Panel

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Leveling leg (screw)

Sold Individually.

Burner mounting screw (screw)

Sold individually.

Inner glass (oven door glass)

Spark ignitor (module)

The function of the ignitor in your range is to create the spark that ignites the gas on the burners. If your spark ignition system is not functioning properly, you may need to replace the ignitor. This part is approximately 3 inches in length. The ignitor is located in the rear of the range, so you will need to remove the back panel in order to access it for this repair. Before beginning this repair, be sure that the gas valve for the range is shut off. You should also disconnect the power source to the range before you begin.

Range oven gas valve (valve)

This gas oven safety valve ensures that no gas is released until the igniter has received the proper voltage needed to ignite the gas range.

Broiler igniter (oven igniter)

This igniter has a short wire harness. The wire length is approximately 6 inches long.

Burner grate - black (burner grate)

Sold individually.

Cap

Sold individually. This part helps the flame to spread for even heat. Also protects your burner head from spills.

Motor (latch motor)

Spark ignition switch assembly with wire harness (igniter harness)

Four switches are included with the assembly.

Overlay

NOTE: Control board is NOT included. Overlay only.