79075657000 Kenmore Range Parts List

Burner cap

Oven probe (sensor)

Also known as a temperature sensor. This part is used to detect the temperature within the oven cavity. **The following instructions only apply if the connector piece is different than the original.** Prior to cutting the leads, please check the length of the wire you will need. 1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together. 2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector. 3. Twist the ends of your new probe and original connector together 4. Use a wire nut, or another high heat fastener to cover your exposed wires. 5. Install your new oven probe and re assembly your oven.

Light indicator - 125v (indicator lamp)

Screw (screw-8-18x1)

Sold Individually.

Spark module (module)

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Outer drawer glide (glide)

As per the factory, the original part was 19 3/4 inches and the new substituted part is 16 1/4 inches. According to the factory, this part will still work with your appliance.

Switch rocker (switch)

Regulator (regulator-pr)

This valve automatically cuts off the flow of gas at a certain pressure.

Dual oven safety valve (valve)

Used for both bake and broil. This part makes sure that no gas is released until the igniter gets enough power to ignite the gas range.

Overlay - white (overlay clock)

This part goes in front of the clock/timer to allow visual indication of where the buttons are on the oven. Example bake, broil & clean. Only available in white. Black version is no longer available.

Small burner base with orifice and igniter (burner assembly)

This part also includes 3 screws. Small burner cap is sold separately.

Oven bottom panel (bottom oven panel)

Oven door handle mounting screw (oven screw)

*Sold Individually. Washerhead Screw 10 - 24 x 1.81