79094313302 Kenmore Range Parts List

Anti-tip kit (anti tip kit)

The anti-tip bracket kit comes with one metal bracket and two installation screws, and is sourced directly from the genuine manufacturer. It prevents the freestanding oven, range, or stove from tipping when force or weight is applied to an open oven door. The bracket is secured to the floor and wall and fits over the rear leveling leg in the back of the appliance, in a cutout specifically designed for the anti-tip bracket. This part is very essential to the safe operation of the appliance. Failure to install the bracket properly can result in the oven tipping or falling and causing injuries.

Oven door seal with clips (oven door seal)

Also known as gasket.

Broil element (broiler element)

This broil element is located on the top inside the oven.

Screw (screw-8-18x1)

Sold Individually.

Light indicator - 125v (indicator lamp)

Screw

This is an authentic mounting screw, which works with ranges, wall ovens, cooktops and warming drawers.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Terminal block kit with ground (terminal block)

This part is found between the rear wall shield and back panel.

Overlay (blk clk ovly)

This part is a replacement clock overlay for your range. It is black in color and approximately 7 inches by 3 inches. The clock overlay is found on the control panel, and it covers and labels the selection buttons of the oven control board. If the touchpad will not respond, or the oven will not start, you may need to replace the clock overlay. Be sure to disconnect the range from the power source before you begin this repair. This part is sold individually and is an authentic OEM part.

Radiant burner element with limiter - 8 inch - 2200w (burner)

Inner door glass (oven glass)

Terminal block screw (screw)

Size: 6-20 x 0.312 inch. Sold individually.

Wafer head screw (oven screw)

Insulation