79095262990 Kenmore Range Parts List

Oven probe (sensor)

Also known as a temperature sensor. This part is used to detect the temperature within the oven cavity. **The following instructions only apply if the connector piece is different than the original.** Prior to cutting the leads, please check the length of the wire you will need. 1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together. 2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector. 3. Twist the ends of your new probe and original connector together 4. Use a wire nut, or another high heat fastener to cover your exposed wires. 5. Install your new oven probe and re assembly your oven.

Broiler pan grate insert (insert broil)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean-up easier. This is a genuine OEM part.

Oven light socket (light socket)

The light socket is located inside the oven cavity to provide power to the light while holding the light bulb in place. If the light bulb is not working, the switch might have failed and will need to be replaced. This is a genuine OEM part. Please remember to disconnect power to the oven before starting your repair.

Element (burner)

Switch rocker (switch)

Oven door handle mounting screw (oven screw)

*Sold Individually. Washerhead Screw 10 - 24 x 1.81

Surface indicator light - 250v (light lamp)

Door hinge with spring (oven door hinge)

Sold Individually.

Oven door seal with metal mounting clips (seal)

Insulation

Support (support-el)

Pin (pin guide)

Clock/timer (clock timer)

Insulation

Spacer

Sold individually.