Maytag Cooktop Elements and Burners

Surface Burner Receptacle Kit

1 Review

Part Number: 12001676

The surface burner terminal block kit includes one plastic block, metal bracket, wires, and high-temperature nuts. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This part is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

Standard Y-Frame Range Surface Burner

3 Reviews

Part Number: WP660532

This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.

Receptacle Kit

1 Review

Part Number: 814399

This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.

X-Large Burner Head with Electrode

4 Reviews

Part Number: 74007736

This is the burner head and electrode for your gas range. If your gas igniter glows but will not light, or if the element will not start or heat entirely, you may need to replace the burner head. This burner head is approximately 4¼ inches in diameter and is sold individually. Please note that the mounting screws for this burner head are sold separately. To replace the burner head, simply unscrew the old, defective burner head and screw in the new one.

Element with Limiter 6 Inch - 1200W

5 Reviews

Part Number: W10823711

This 6 Inch 1200-watt radiant surface element with limiter is located under the main cooktop. When the element is turned on, it will heat up and provide heat to the cooking area on top of the range. If your element will not supply heat you will need to replace it. When replacing the radiant surface element please make sure the element is cool to touch before starting the repair. Disconnect the power to your range before beginning the repair. This is a genuine OEM part.

Dual Surface Element - 2500w/1200w

2 Reviews

Part Number: W10823692

The large surface element is installed under the cooktop and heats up the area directly above it. It is approximately 10 inches in diameter and is 1200/2500 watts. If your element is not heating up, you may need to replace the element or check the burner switch. This part a genuine OEM part. Please remember to disconnect the power to your range before starting your repair.

Delta Frame Surface Unit - 8 Inch

Part Number: WPY04100166

This 8 inch surface burner with reinforced delta frame carries 2100 watts and 240 volts. It has five turns and is compatible with many electric ranges. Its center medallion is all black in color.

Large Burner Head

3 Reviews

Part Number: 74007735

This part includes the spark igniter.

Surface Element - 6 Inch

2 Reviews

Part Number: WPW10259868

This surface burner heating element is six inches in diameter. It has four turns and looped terminal ends. This element provides heat to the cooking surface on your range. If your element is not heating, you may need to replace this part. Make sure the power has been disconnected and the element is turned off and cool before starting your repair. The element is a genuine OEM part. It is sold individually.

Delta Frame Surface Unit - 6 Inch

1 Review

Part Number: WPY04100165

This surface burner heating element with reinforced delta frame is six inches in diameter, has four turns and looped terminal ends. It carries 1250 watts, 240 volts and the center medallion is black in color. This element provides heat to the cooking surface on your range. If your element is not heating, shorted out around the coil, or the terminal block shorted out and damaged the ends on the element, you may need to replace this part. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. The element is a genuine OEM part and is sold individually.