Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
You can view or search all the parts in each section by clicking on the diagram to the left of each part.
This water filter has been updated by the manufacturer. It may appear different but will still function the same. No tools are required to replace your water filter. It is sold individually....
The door cam helps keep the door closed in the correct position. The cam is mounted around the door pivot point and is made up of a series of ridges and valleys to help keep the door in posi...
This icemaker can be used with 25-27 cubic feet refrigerators that have a vertical auger dispenser located on the freezer door. Reuse bottom bracket from the original icemaker and attach to...
This ice guide is in the freezer door located in the dispenser section. This part helps the ice be guided from the dispenser to your cup once activated. If the ice maker will not dispense ic...
This black cap covers the water filter.
This grille is located on the bottom of the ice/water dispenser to catch the overflow. (Black)
This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. It also controls the heater, the water inlet valve, the cube size, and cube ejection...
This part has a clear plastic front. The bins are sold individually.
This fan motor is used in frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, to cool the compressor ...
This ice door is used to seal off the ice chute when not in use. When in use the door will open in the dispenser chute to allow ice to be dispensed. This kit includes the ice door, support, ...
This 25-watt, 120-volt light bulb is 2.5 inches long. It has a small, screw-in base and it is used in many different appliances. If your current bulb is burnt out or broken you will need to ...
This set of two electronic control boards contains both the emitter and the receiver. These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the ic...
The end cap trim piece slides into the door trim to help hold the door shelf stay in place. When installing the new end cap trim piece, make sure the two small taps are facing up. This part ...
Door switch turns the light off when you close the door.
If ice is building up in your freezer or if your freezer is getting too warm on the defrost cycle you may need to replace the bi-metal thermostat.