Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
You can view or search all the parts in each section by clicking on the diagram to the left of each part.
Sold Individually - 2 screws needed to mount each handle.
This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator...
Sold Individually - Appliance originally takes 2.
Both bottom door hinges are included in this set.
This motor rotates the auger. When the auger rotates, it pushes ice out of the bin, through a chute to the user.
This clip is sold individually.
Anti drip valve NOT included.
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.
Sold Individually.
This dispenser door pin comes with the washer.
This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.
This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited int...
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.
This door trim is located on the inside of the fridge/freezer door. It is held in with two end caps, and is used to store items in the door.
This door gasket is used to make an air-tight seal for the cabinet when the door is closed.