GBE22AA0CP P1137542NW Amana Range Parts List

Chrome drip bowl - 8 inch (chrome drip bowl - 8")

This eight-inch chrome drip bowl is intended for use with rolled terminal style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Drip bowl - 6 inch (chrome drip bowl - 6")

This six-inch chrome drip bowl is compatible with electric ranges that utilize plug-in surface burners. This bowl measures approximately 7 2/3-inch in diameter. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.

Surface burner plug-in block kit (kit, top element term)

This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.

2 piece broiler pan (sub 12500100)

The broiler pan and insert allows you to cook on a stable surface while allowing the liquid to drain into the pan below, making clean up easier. The measurements for the pan set are 1-1/2-inch x 12-3/4-inch x 16-3/4-inch and is a genuine OEM part.

Economy y-frame surface unit - 8" (element, 4 turns (210)

This electric range economy Y-frame surface element measures eight inches and has five turns. It carries 2100 watts and is used on some electric ranges. The center medallion is chrome.

Surface infinite switch (switch-infinite)

Economy y-frame surface unit - 6" (element, 3 turns (125)

This electric range economy Y-frame surface element measures six inches and has three turns. It carries 1250 watts and is used on some electric ranges. The center medallion is chrome.

Installation screw (scr-# 8x3/16 pan hd)

This screw is sold individually.

Stand mixer screw (screw,philip pan hd 1)

This screw is sold individually.

Frame screw (screw, #10-12 x 500"")

Sold Individually.

Main power terminal block (terminal block)

Sold individually.

Leveler (leveling leg)

This is an OEM part that is made of metal and sold individually. The leveling leg is generally used with refrigerators, dryers, freezers, ranges, cooktops, and microwaves. The leveling leg is meant to keep your appliance steady and level to the floor. If you notice your appliance is uneven to the floor it may need to have the leveling leg replaced. You will notice that the bottom of the leveling leg has a smooth surface to ensure moving your appliance does not require as much effort. This part screws into a pre-drilled hole underneath the appliance.

Oven sides seal (seal, oven-sides)

It is made of black rubber and has a metal hook in each end.

Burner knob (knob, burner *)

Sold individually. This knob accepts a D-shaped shaft.

Receptacle mounting bracket (mounting brkt. Plug b)

This terminal block mounting bracket is a little over two inches long. It is made of metal.