RB15CN-2A 4A73B Parts List

Condenser fan motor kit (sub 12001314)

This condenser fan motor is used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compressor and condenser coils. This part also helps to evaporate excess water in the drain pan. If your refrigerator/freezer section is too warm you may need to replace this part. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Screw (sub 71001183)

This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.

Ice cube tray (sub 61002140)

This 48 cube ice cube tray is eleven inches long. It is all white in color and it is made entirely of plastic.

Screw

Sold individually.

Evaporator fan motor - 115v 60hz - blade not included (evaporator fan motor)

The evaporator fan motor circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. This part is 115 volts, has a 3/16th-inch shaft and is just over three inches long. It is made of both metal and plastic, and is made up of black, white, and metallic pieces. This evaporator fan motor is a genuine OEM part. Please remember to disconnect the power to your appliance before starting the repair.

6-hour defrost timer (sub 66128-1)

This part may appear different than the original, but will function the same. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

Defrost heater - 400w 115v (defrost heater)

This radiant glass defrost heater is eighteen inches long. It comes with an instructions sheet, and is intended for use with the freezer evaporator of some refrigerators.

Defrost evaporator pan (sub 68236-1)

This defrost evaporator and water collection pan is almost sixteen inches long. It is all black in color and it is made entirely of plastic.

Speed nut (sub 19914)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Defrost thermostat - with wire and clip (sub 52085-28)

This refrigerator defrost thermostat will cut out at 80 degrees Fahrenheit and kick back when the temperature drops to 15 degrees Fahrenheit.

Rivet (sub 210720)

This rivet is an inch and a half long. It is used for many washing machines, microwaves, refrigerators, dryers, and ranges. Use of this rivet requires a rivet tool.

Screw (sub 61005388)

Sold Individually.

Drier (service) (sub 13900-1)

The ultra violet drier is used in conjunction with your refrigerator. This part acts as a filter for the refrigerant that moves thought the seal system in your refrigerator. If your refrigerator is not working properly or starting you may need to replace this part. It is recommended to have this installed by a service technician because it will require to recover and recharge the refrigerant in the sealed system. This is a genuine OEM part.

Bracket grommet (grommet, bracket)

Blade- con (sub 69958-1)