Whirlpool Dishwasher Caps and Lids

Rinse-Aid Dispenser Cap

5 Reviews

Part Number: WP8558307

The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.

Rinse Aid Cap

3 Reviews

Part Number: WPW10524919

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Rinse Aid Cap

1 Review

Part Number: WPW10077881

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Rinse Aid Cap

Part Number: WP3378134

This cap does not require the use of a o-ring seal.

Rinse Aid Cap

2 Reviews

Part Number: WPW10524920

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws in to the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Tub Cap

1 Review

Part Number: W10795980

The plastic button covers the sharp ends of screws along the edge of the dishwasher tub. Sold individually.

Rinse Aid Cap

1 Review

Part Number: WP8564929

This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.

Dispenser Cap

1 Review

Part Number: WP8533380

This is the cap for your rinse aid dispenser.

Cover

Part Number: WPW10455272

Rinse Aid Cap - Gray

1 Review

Part Number: WPW10524922

This is the replacement rinse aid cap for your dishwasher. It is made of gray plastic and is approximately 2 inches in diameter. This rinse aid cap screws into the rinse aid assembly and prevents leaks. Sometimes the cap can become loose and fall out, which can cause it to be melted by the heater. If your cap is damaged or missing, this is the part you will need to replace it. This rinse cap is an authentic OEM part sourced directly from the manufacturer and is sold individually.